This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
SIS input tables active in DF2 without the H module
26-04-2016, 10:34 AM, (This post was last modified: 26-04-2016, 10:35 AM by shaswin.)
#1
SIS input tables active in DF2 without the H module
In Ple4Win v4.4.0 the SIS input tables are active in DF2 without the H module. Is this standard?
It is strange that SIS input tables are working without the H module.
26-04-2016, 11:13 AM,
#2
RE: SIS input tables active in DF2 without the H module
This is indeed strange! I re-checked, and it appears that your observation is correct. The SIS-input tables are available, which should not be the case.

Note however, that you still can't use SIS without the H module. If you enter data in SISSECT, DF2 can not be calculated. If you enter data in SISPRC only, that data will be ignored. In both cases an error or a warning is reported in the Warnings-table.

I assigned ticket no. J-1876 to this issue.
10-05-2016, 09:38 AM,
#3
RE: SIS input tables active in DF2 without the H module
This issue will be fixed in the new build that will be released this week.
10-05-2016, 10:48 AM, (This post was last modified: 10-05-2016, 10:56 AM by shaswin.)
#4
RE: SIS input tables active in DF2 without the H module
(10-05-2016, 09:38 AM)P Herwig MSc Wrote: This issue will be fixed in the new build that will be released this week.

Paul,

You can also also do a quick fix for this issue in the helpfile when releasing the new build.

Thanks.
20-05-2016, 11:31 AM,
#5
RE: SIS input tables active in DF2 without the H module
The new build has been released, if you want to install it make sure an already installed version 4.4.0 is uninstalled prior to installing the new build. Otherwise installation will fail, as the version number is unchanged.


Forum Jump:


Users browsing this thread: 1 Guest(s)