This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Strange E310/11 error in project file
17-06-2016, 12:30 PM, (This post was last modified: 17-06-2016, 01:34 PM by shaswin.)
RE: Strange E310/11 error in project file

Why isn't this possible. It can be fixed by converting it internally to all in RTOL or all in ATOL. I am not using ATOL1 and RTOL1 together or ATOL2 and RTOL2 together.
There are two different materials that are welded at identifier D30MV14 to each other, which has also difference (discontinuity) in nominal wall thickness and wall thickness tolerance.
This is specified by the material codes. I can convert it to one type wall thickness tolerance, but it would be nice if Ple4Win could do that for me. I think the interpolation of the minimum wall thickness can be done when the ATOL1 is abstracted from T-NOM1 and RTOL2 is abstracted from T-NOM2.

Messages In This Thread
RE: Strange E310/11 error in project file - by P Herwig MSc - 15-06-2016, 10:42 PM
RE: Strange E310/11 error in project file - by shaswin - 17-06-2016, 12:30 PM

Forum Jump:

Users browsing this thread: 1 Guest(s)