This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Strange E310/11 error in project file
21-06-2016, 08:20 AM,
RE: Strange E310/11 error in project file
As I said, it should be possible, but currently it doesn't work correctly.

Note further that in your case you did not define a situation where 2 materials are welded together. That would imply a step change in the definition of the WALL table at that point (requiring e.g. RTOL1 and ATOL2), which isn't there initially.
What you defined is a gradual change from one ident to the next, where one ident has a relative talerance and the next one an absolute one. I can't imagine this to happen in a real-life situation, but still the program should be able to handle this situation.

So yes, we are going to work on this, in the mean time use the workaround as described.

Messages In This Thread
RE: Strange E310/11 error in project file - by P Herwig MSc - 15-06-2016, 10:42 PM
RE: Strange E310/11 error in project file - by Dr. J Foerster - 21-06-2016, 08:20 AM

Forum Jump:

Users browsing this thread: 1 Guest(s)