This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
To add print date in the MultiGraph output
26-01-2017, 11:16 AM,
#1
To add print date in the MultiGraph output
Is it possible to add the print date after the license number in a Multigraph output. One can then check if the graph is actual or not.

Thanks.
Reply
03-02-2017, 12:39 PM,
#2
RE: To add print date in the MultiGraph output
That might be a possibility, all graphs (single graph, polar graph and multi-graph) currently do not show the printing date.
With tables, a date is shown, however, this is not the printing date but the date the table was successfully tested.

I assigned ticket no. J-716 to this request.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)