This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Combined bends #2
04-02-2017, 07:32 PM, (This post was last modified: 04-02-2017, 07:45 PM by shaswin.)
#3
RE: Combined bends #2
Hello Bas,

You can use the combined bend radius at the tangent point where the overlap exists, see formulae NEN 3650-1:2012 E.1.2.4.2:

   

Create also new tangent points as Jens also explains for the horizontal and vertical bends before and after the combined bend. You can do an exact calculation in Excel where the extra tangent points (X,Y,Z) should be. So you have multiple bend radius connecting with each other without any kinks.
Reply


Messages In This Thread
Combined bends #2 - by Bas - 31-01-2017, 01:14 PM
RE: Combined bends #2 - by Dr. J Foerster - 03-02-2017, 11:43 AM
RE: Combined bends #2 - by shaswin - 04-02-2017, 07:32 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)