This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
12-07-2017, 11:11 AM,
You are right, the help file is unclear in this. We will clarify this. I assigned ticket no. J-2043 to this issue.

The program does use the outer diameter, by the way. For thin-walled pipelines (the main focus of the program) this is a justifiable choice.
But we will discuss internally whether we will keep it that way or use the average diameter in the future (or even use different diameters depending on pipe material and relative wall thickness).

Messages In This Thread
W+WD/D-M in RMAXNEN or RDPLMX - by shaswin - 23-03-2017, 12:54 PM
RE: W+WD/D-M in RMAXNEN or RDPLMX - by Dr. J Foerster - 12-07-2017, 11:11 AM
RE: W+WD/D-M in RMAXNEN or RDPLMX - by shaswin - 13-07-2017, 12:34 AM

Forum Jump:

Users browsing this thread: 1 Guest(s)