RE: Unexpected results in joints rotation
Hello Rien,
Thanks for your answer. I'm aware of the big displacement I input there.
I also put a MaxRot of 90 degrees in the same input table.
The real numbers are about 14 mm inwards and outwards displacement.
And a maximum rotation of 3 degrees.
But with these numbers I got a maximum rotation of 3 degrees, with a STOP.
If I use, for example, a MaxRot of 10 degrees, I get a resulting rotation of 10 degrees, with a STOP.
If I use 20 degrees, I get a rotation of 20 degrees, with a STOP, etc..
All the way up to the (unrealistic) numbers in the model I attached.
This seems unexpected.
In this testmodel I've only used sand, and there is not even SETZ.
So you would expect minimal displacements of the pipe.
And so you would also expect minimal rotations in the joints.
