This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Error in calculation DEADW
06-10-2017, 09:36 AM, (This post was last modified: 06-10-2017, 10:05 AM by shaswin.)
RE: Error in calculation DEADW
The error E310/11 did not occur in this project file with strange results in the DEADW output column. All horizontal pipes are under water and vertical pipe is partly under water. That was the case here. It will succesfully test the input table and the error E310/11 did not occur.

It would be nice to make it possible to have empty and non-empty WLEVELS for this project case.

Messages In This Thread
Error in calculation DEADW - by shaswin - 04-10-2017, 05:00 PM
RE: Error in calculation DEADW - by shaswin - 06-10-2017, 09:36 AM
RE: Error in calculation DEADW - by shaswin - 06-10-2017, 10:43 AM

Forum Jump:

Users browsing this thread: 1 Guest(s)