This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Selection of multiple GROUPS
20-07-2018, 09:16 AM, (This post was last modified: 20-07-2018, 11:56 AM by shaswin.)
#1
Selection of multiple GROUPS
Prior to Ple4Win v4.5.0 it was possible to select multiple GROUPS and view elements of multiple groups I thought:

   

This is not possible in the new version. This can be handy when you have different material quality and want to check the membrane stresses at the support elements, etc. It would nice if it this request was possible again.
Reply
20-07-2018, 02:32 PM,
#2
RE: Selection of multiple GROUPS
No, it was not possible to select multiple groups in earlier versions of the program.

And yes, we are already thinking of redesigning the groups functionality: We not only want to have the possibility to select multiple groups, we also want to redesign / reorder the way the groups are shown, as the list is becoming too long for proactical purposes.

I assigned ticket no. J-1006 to this request.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)