This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Corrosion allowance and fabrication tolerance of a tee
14-12-2009, 12:06 PM, (This post was last modified: 14-12-2009, 12:08 PM by shaswin.)
#1
Corrosion allowance and fabrication tolerance of a tee
Ple4Win assumes that the corrosion allowance and fabrication tolerance of a tee has the same values as the matching pipes.
Often this is not the case.

I know it is also possible to give a higher tolerance and corrosion allowance in the WALL table.

Giving a lower value for the T-RUN and T-BRN will give different SIF factors.

Is it possible to extend the TEESPEC table with the corrosion and fabrication tolerance?
Reply
16-12-2009, 10:33 AM,
#2
RE: Corrosion allowance and fabrication tolerance of a tee
Thank you for your input.

We have noted your request. I have no idea yet what the implications of your request are, but we will discuss it with our team.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)