This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Loadfactor for internal pressure can be higher according to NEN3650
19-03-2010, 08:55 PM, (This post was last modified: 19-03-2010, 09:04 PM by shaswin.)
RE: Loadfactor for internal pressure can be higher conform NEN3650
Yes, adding the BC2 loadfactor in LOCASE table is much better.

Multiple rows in the LOCASE would be great, so one could insert different loadfactors at a specific IDENT/AX-L/AX-LP. So a transition in loadfactor could be made at any point in the configuration:

1. transition between Rotterdam loadfactors and NEN3650 loadfactors;
2. transition between different materials (for example transition between steel and polyethylene);
3. transition between pipelines outside and inside a station;
4. transition maximum incidental pressure (MIP) and default internal pressure.

Messages In This Thread
RE: Loadfactor for internal pressure can be higher conform NEN3650 - by shaswin - 19-03-2010, 08:55 PM

Forum Jump:

Users browsing this thread: 1 Guest(s)