List of data for bend elements only (Output Table)

Table description:

The output data table BENDELM is an element based table where only bend elements are reported.

The table provides information on the type of bend element, the flexibility data and on the stiffness reduction factors that have been calculated in the bends and have been used in the composition of the pipe stiffness matrix.

Loadcase name and phase number, if applicable, are shown in the table heading.

If there are no bends, table BENDELM will not be produced.

In case of a mitre bend, the RADIUS is the equivalent bend radius on which the calculations are based. In table SHAPEP the geometrical radius is reported.

 


 

H500672, last changed: 4/16/2018

See also:

Data description/conditions

Table error description

Table BENDFAC

Design Function 5